Basic operation
• Use AC 100-240V 50~60 Hz power outlet for
the product power supply
• lf the screen of the product is not on, please
press the power button on the remote control
or on the product
• lf you want to shut off the product temporary,
please press the power button on the remote
control or on the product
• lf you want to shut off the product completely,
please disconnect the power cable
• In Component and AV modes the product
will shut off if there is no signal input for 30
minutes
• ln PC-RGB and HDMI modes the product will
enter idle state if there is no signal input after
30 seconds
• ln Media Player 1/2 modes the product will
remain On if there is no signal input
• The setting and tuning of picture and sound
will be saved when the product is shut off,
which will be working in the pre-shut off state
when the product is turned on again
• lf PC signal source is used, please first set
the resolution of the PC display card as the
following modes:
For HDMI 1/2/3 (3840x2160 @ 60Hz)
For PC (1920 x 1080 @ 60Hz)
• lf there is progressive output of the signal
used by the user, signal source with
progressive output is recommended
Preparation
• Put the product on a stable surface
• Do not fix the product with others fixations than
those provided or suggested by the
manufacturer
• If you have a wall mount, check that it is
steady.
• Do not place any material on the product.
• Do not block or cover the ventilation
openings on the product
• The product must be plugged with a tension
source of 110-240 volts and 50~60 Hz
• Power cord and cables must be properly
routed and protected to prevent from
stepping on them
• Keep the power cord away from any heat
source. Possible fire hazard
Heating sources and humidity
• Keep the product dry and away from humidity
• Keep the product away from heat sources
Cleaning and maintenance
• Unplug the product before cleaning it. Do not
use solvents or liquids to clean the product
• Only clean the product with a soft and dry
fabric
• In case of troubleshooting, do not use spare
parts other than those suggested by the
manufacturer. Using inadequate spare parts
can lead to electric shocks, short-circuits fire
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS
TO RAIN OR MOISTURE
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER(OR BACK). REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL
or others incidents. Please contact a
technical authorized by SWEDX
Departure in holidays
• Unplug the product during lightning storms or
when unused for long periods of time
05
To Next Page
Loading...
