SWEED CE300AF - Bolt Torque Specifications

CE300AF
Page 11 of 15
Incrementally
Always tighten fasteners incrementally in a pattern up to the
torque specifications where applicable.
Table
Critical fasteners and their required torque specs are listed in the
table below:
14 Bolt Torque Specifications
Knife Bolts Initial
Torque
40 N-m (30 ft-lb) (0.15 max friction coefficient lubricant req.)
Knife Bolts Second
Torque
68 N-m (50 ft-lb)
Knife Bolts Final
Torque
84 N-m (62 ft-lb)
Flywheel Bearing
Bolts Torque
73 N-m (54 ft-lb)
Flywheel Bushing
Bolts Torque
12 N-m (9 ft-lb)