Sweepster WSP36 series User Manual (English)

Other manuals for Sweepster WSP36 series

Questions and Answers:

F
Fernando WilliamsAug 13, 2025
Why does the Sweepster Blower brush slow down or stop while I'm sweeping?
- S
  sharonhughesAug 13, 2025
  There are several reasons why the brush might slow down or stop: * The idler may not be engaging, in this case you should adjust the turnbuckle. * The air filter could be clogged, so you should change or clean it. * Your travel speed may be too fast - travel no more than 5 mph while sweeping (1-3 mph is recommended). * You might be trying to sweep too much material at once; try making several passes with the sweeper.
R
Rhonda GarciaAug 16, 2025
What to do if the Sweepster WSP36 Blower traction drive slips?
- A
  April SmithAug 16, 2025
  If the traction drive is slipping, it could be due to a couple of reasons. First, the idler may not be working properly; try adjusting the turnbuckle. Alternatively, the belt might be worn and need replacement.
M
Michael ConradAug 20, 2025
Why does the Sweepster Blower brush head assembly bounce during sweeping?
- H
  Hannah McintyreAug 20, 2025
  The brush head assembly might be bouncing because the travel speed is too fast, and/or the brush speed is too slow. Find the correct combination of ground and brush speeds, and do not travel at more than 5 mph.
R
Richard MccoyAug 23, 2025
How to fix a Sweepster WSP36 Blower brush that wears into a cone shape?
- A
  Amanda MeyerAug 23, 2025
  A brush wearing into a cone shape can be caused by improper tire size or under inflation. Check the tire sizes and rating, and make corrections as necessary.