Swegon GOLD RX/HC 020

Questions and Answers

K
Kristen BlevinsAug 9, 2025
What to do if my Swegon Heat Pump compressor is not operating?
- J
  Justin BensonAug 9, 2025
  If the compressor is not operating, there are several potential causes. First, check the operating or safety switch, as the voltage may have been isolated. Second, verify and correct the phase sequence if it's incorrect. Third, check the condition of the fuses, as the compressor safety circuit may have been broken. Finally, if none of these resolve the issue, the compressor may be defective and require replacement.
T
Travis FoleyAug 15, 2025
Why is my Swegon Heat Pump capacity too low?
- L
  lisa31Aug 15, 2025
  Several factors could cause a reduction in your heat pump's capacity. Begin by checking the operating or safety switch to ensure the voltage hasn't been isolated. Also, inspect the evaporator for proper airflow. If airflow is insufficient, address the blockage. Additionally, check for refrigerant leaks and replenish if necessary. Finally, examine the thermostat or control equipment settings and replace any faulty components.
R
Richard PerryAug 21, 2025
What to do if my Swegon Heat Pump compressor switches off due to low pressure?
- A
  Amber DoyleAug 21, 2025
  If the compressor shuts down because of low pressure, possible causes include: insufficient refrigerant (indicating a leak in the cooling system, which should be tightened and recharged), inadequate airflow across the evaporator (so check the airflow). It could also be a defective expansion valve or a faulty low pressure switch, both of which should be checked and replaced if necessary.
Q
qfoxAug 27, 2025
What to do if my Swegon Heat Pump compressor shuts off due to high pressure?
- S
  spencerdouglasAug 27, 2025
  If the compressor is switching off due to excessively high pressure, it could be due to several reasons. Start by checking the airflow across the condenser. Also, check the exhaust air temperature. Finally, the high pressure sensor itself might be defective and require replacement.
B
Bethany MendezSep 1, 2025
Why is there significant freezing on the evaporator of my Swegon Heat Pump?
- M
  Matthew VasquezSep 1, 2025
  If there's significant freezing on the evaporator, it could be due to a defective or incorrectly set expansion valve, so you should check it. Another possible cause is insufficient airflow across the evaporator, so check the airflow.