3
CONDUCTOR
Swegon reserves the right to alter specifi cations 20090310 www.swegon.com
User manual
About CONDUCTOR
CONDUCTOR is a regulation system for controlling the
room temperature and air quality. You can create a com-
fortable indoor climate by keying heating, cooling and
airfl ow settings in the room unit. When you leave the
room, the system automatically regulates the climate until
you enter a new temperature or airfl ow setting.
In the automatic mode, the CONDUCTOR will regulate
heating and cooling dependent on the circumstances in
the room: is anyone in the room, is a window open, is
the room air humid?
This instruction describes how you as day-to-day user of
the CONDUCTOR, offi ce worker or hotel guest, using the
room unit can manually regulate the heat, coolness and
air quality in the room.
The parts of the room unit
Figure 1. The room unit.
1Display
Shows the current status of the climate system and
information about the room temperature and airfl ow.
It also shows the settings you enter with the key set.
2Key set
You use it for changing room temperature and air
volume settings.
3 Temperature sensor
Placed inside the enclosure.
N.B.! In that the measurement of the temperature is in-
fl uenced by the surroundings, the measurement of the
room temperature, dependent on where the room unit
is located, is not necessarily representative of the actual
heating or cooling requirements of the room.
To use the CONDUCTOR
The following section describes how you use the room
unit to adjust the room temperature and airfl ow.
The key set
You use the key set to raise and lower desired room tem-
perature and increase and decrease desired airfl ow.
Figure 2. The key set.
1 The keys for adjusting the temperature
▲ UP To increase the temperature.
▼ DOWN To decrease the temperature.
2 Keys for adjusting the airfl ow
◄ LEFT To decrease the airfl ow.
► RIGHT To increase the airfl ow.
3
Accept key for temperature and airfl ow
OK CONFIRM Confi rm the setting.
To Next Page
Loading...
