EasyManua.ls Logo

swepac FB 160 - Before Starting; STARTING, Petrol Engine; After Starting; Stopping

swepac FB 160
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
FB160 / FB170 / FB175 / FB235 / FB255 / FB265
spac103
spac107
Dok: 101497C-GB 2126
On
O
OpenClosed
Throttle lever
Fuel cock
Oil level Engine power switch
Choke
See Daily Checks on page 8.
BEFORE STARTING
STARTING – Petrol Engine, FB 160 /
FB 230
AFTER STARTING
STOPPING
Switch the engine power switch to “1”.
Open the fuel cock.
Switch the throttle lever to “MIN”.
Adjust the choke. If the engine is cold, close the choke
completely. Do not use the choke if the engine is warm
or if the air temperature is high.
Start by pulling the
starting handle. Pull it
rst until the mecha-
nism engages. Then
pull it hard and fast.
Switch the throttle lever to idle.
Open the choke gradually.
Run the engine warm for around 5 minutes.
Switch the engine to idle and let it run for a few
minutes.
Switch the engine power switch to “0”.
Close the fuel cock.