Swift Group Select 164 - 2.15 Heating Controls

ELECTRICAL SYSTEMS
70
ELECTRICAL SYSTEMS
ELECTRICAL SYSTEMS
70
SWIFT COMMAND POWER CONTROL SYSTEM
2.15 Heating Controls
There are a number of heating systems that
can be controlled by the power control system.
The system will be preconfigured by the
manufacturer or supplying dealer. The related
control panel screens are shown below.
Heating screen
Here you can control the heating system,
select energy and temperature and by
pressing the more button (right arrow) you can
set related timers.
Mode
Set the mode to Manual to use the
controls supplied by the heating appliance
manufacturer. Set the mode to Timer to
control the appliance by the EC800 control
panel.
Note: The mode will automatically change
to App when you control the appliance by
the Swift Command app.
Status Temp Water
The status box shows you which timer is
currently active, and the temp and water
boxes show the target room temperature
and water heater setting for the active timer.
Override
When operating in timer mode you can
temporarily ‘override’ the timer room
temperature by using the override feature.
Press the centre of the dial to turn the
override on / off. Press the (+) or (-) buttons
to increase or decrease the required
temperature.
Note: You can also override the room
temperature by making a change using
the appliance control panel (Alde & Truma
only). If you make a change the override
will automatically activate. The override
temperature will continue until the next timer
event time.
Truma CP+ Energy
Truma CP+ Energy
The energy, gas or electric setting will vary
depending on the appliance type.
For Truma Combi+ heating press the
energy button to step through the available
settings. Gas is indicated by the flame
symbol and electric indicated by the
lightning symbol. Possible combinations are
GAS, MIX1, MIX2, EL1 or EL2. One electric
symbol=1KW and two=2KW.
Note: Changes made on the EC800 control
panel may not be accepted on the heating
controller immediately if the controller has
been recently used and still has its backlight
on. Please try to use one controller at a time.