Swing DIAMOND - Mains Connection; Down Rod and Ceiling Cover Assembly

4. Installing the ceiling fan at an angle
This fan can be installed at a ceiling slope of up to 15 degrees.
3. Mains connection
Connect the mains supply 220-240V to the terminal block in accordance with the markings.
Installation instructions
5. Assembling the down rod and the ceiling cover
- Loosen the screw of the ball-joint and remove the pin of the ball-joint, so that it allows the ball-joint to be disassembled
from the down rod.
- Thread the wiring through the motor adapter cover, the decorative cover, the ceiling cover, and the down rod.
- Place the down rod on top of the fans motor housing and align the holes.
- Insert the pin through the extension rod (make sure the wires are not damaged) and insert the security pin.
- Slide the motor adapter cover over the fan motor housing.
- Reassemble the ball-joint and ensure proper installation of the ball-joint pin and the ball-joint screw.
Attention! Perform the assembly of the down rod and the upper cover with manual and non-electric tools.
Attention! It is mandatory to tighten the 2 screws of the down rod to the fan motor housing.
Ball-joint
Ball-joint pin
Down rod
Down rod
Decorative cover
Security pin
Fan motor
The motor adapter cover
Pin
Down rod screw
Ceiling cover
7
SWING DIAMOND Fan Installation Instructions | Version 1.23
6