EasyManua.ls Logo

Swisher ST50022STDQ - Trimmer Operation; Preparation and Trimming

Swisher ST50022STDQ
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Preparing Unit For First Use
Fill engine crankcase with oil. A bottle has been provided with this unit. DO
NOT OVERFILL.
Fill the engine fuel tank with gasoline. GASOLINE SHOULD BE ADDED
OUTSIDE IN A W ELL-VENTILATED AREA.
Check to ensure string has been installed properly. A diagram is provided
just above the wheel for proper installation.
Operation
Remove any built up debris from engine.
Pull control bail against the handle and hold.
Push primer button on engine as directed.
Pull back sharply on recoil starter handle.
Begin trimming.
Important! For safest operation, make sure debris is directed away from you and others.
Important! 12 Volt Units. For optimum battery performance, you should run engine for at least 15
minutes after each start to keep battery charged
To stop the trimmer:
Release the control bail. Engine will stop immediately.
Do not lift the trimmer head when trimming. Let the head rest lightly touching
the ground.
Keep an eye on the length of the trimmer strings. As the strings get shorter
they become less effective at cutting and will take longer to trim properly.
Replace the string as necessary. (See installing string)
Do not trim wet grass.
Use caution when trimming slopes.
Use the proper length of string. Using a string too long for the unit will cause
stalling and unacceptable operation.
Trimming Hints
Important! To ensure proper operation, clean the engine and trimmer
regularly. See page for details.

Other manuals for Swisher ST50022STDQ

Related product manuals