Swisslog corob D200 - User Manual

Questions and Answers

K
Kimberly WaltersAug 14, 2025
What to do if there is an error in communication with my Swisslog corob D200 Dispenser?
- E
  Edward MontesAug 15, 2025
  If you are experiencing an error in communication with your Swisslog Dispenser, here are a few things you can check: 1. Verify that the serial cable between the machine and the PC is securely connected. 2. Ensure that the serial port is functioning correctly and that the serial port configuration in ColorTECH is accurate. 3. As a last resort, try changing the CBMASTER board.
R
robert26Aug 18, 2025
How to check the sensor on a Swisslog corob D200?
- P
  pamela55Aug 18, 2025
  To perform a sensor check on your Swisslog Dispenser: 1. Open the front panel and check that the sensor light is working correctly. 2. Inspect the cable, looking at LED D4 on the CBMASTER board. 3. If necessary, replace the sensor.
A
Alyssa HensonAug 21, 2025
How to check the power supply on a Swisslog Dispenser?
- L
  Lisa WardAug 21, 2025
  To check the power supply of your Swisslog Dispenser, verify that LEDs D1 (42 volt LED), D2 (24 volt LED), and D3 (5 volt LED) are ON on the CBMONO board.
J
Jennifer MurphyAug 25, 2025
How to fix Swisslog corob D200 error 7D00?
- A
  adam94Aug 26, 2025
  To resolve the issue 7D00 on your Swisslog Dispenser: 1. Check the nozzle. If it's not clean, clean it and try dispensing again. 2. Reduce the speed to '500'.
A
Alejandro JacksonAug 28, 2025
How to check the input on a Swisslog corob D200?
- M
  mgarciaAug 28, 2025
  To check the input on your Swisslog Dispenser: * Verify the input voltages as described in the Neutral Phase picture. * Check the output voltage for 24 volts as described in the picture. * Check the output voltage for 42 volts.
H
holly95Aug 31, 2025
What to do if input voltages are present and output voltages are not present in Swisslog corob D200 Dispenser?
- B
  Brandon White Jr.Aug 31, 2025
  If the input voltages are present but the output voltages are not present in your Swisslog Dispenser, replace the power supply unit.
T
Thomas SloanSep 4, 2025
What to do if output voltages are present and leds are not on in Swisslog Dispenser?
- S
  sarah71Sep 4, 2025
  If the output voltages are present but the LEDs are not on in your Swisslog Dispenser, replace the CBMONO board.
M
Matthew BarnesSep 7, 2025
How to fix Swisslog Dispenser error 7B00?
- L
  Larry GutierrezSep 7, 2025
  To resolve error 7B00 on your Swisslog Dispenser, replace the SAPS.
J
Jared OconnellSep 12, 2025
How to fix Swisslog Dispenser error 7C00?
- J
  Jason TuckerSep 12, 2025
  To resolve error 7C00 on your Swisslog Dispenser, replace the SAPS.