11 Monitor output jacks. Used to feed the monitor
amp. The signal here is taken from the monitor
bus, after the monitor level pot and mute switch.
12 Rec output jacks. The recording bus signal before
the rec level pot is presented here.
13 Opto/coax switch. Select whether the digital
in signal is taken from the coax or opto input.
14 Digital in/out RCA jacks. These are the 75 Ω
coax digital i/os.
15 Digital in/out TOSLINK jacks. These are the
optical connectors for digital i/o. Keep them
covered when not in use.
16 USB connector. The USB cable to the
computer plugs in here.
17 Voltage selector switch. Make sure you check
the voltage selector switch setting before
plugging the unit in, or damage can occur.
18 Power connector. The mains cable is inserted
here. Also contains an integral fuse holder.
For protection against fire hazard and unit
damage, make sure you the correct type and
rating of fuse is used for your mains voltage.
9
1
23
4
5
6
8
7
9
1
23
45
99
8
To Next Page
Loading...