@ Open our app, tap "+" located at the right-handed corner of th
home page, select Add Device.
O Find the device icon and select, follow the instructions to add
your device.
Mapping and Marking Water Station Position
O Before mapping, make sure your robot is docked to the Auto
empty Station and is charged. Then follow the in-app instruction
to start mapping. Your robot will automatically return to the Auto
empty Station once mapping is complete, and will save its progres .
Tip:When usingforthefirst-time,shortpressthe(O button,andyourrobotwillstart
mapping while cleaning.
You will need to mark the position of the Water Station on you
map once it is created. Please follow the in-app instructions to
complete.
Please note:
• If your robot failed to find the Water Station when marking, you can try the followin .
Manually dock your robot to the Water Station. When successfully docked, press th
o button, and your robot will leave the Water Station, relocate itself, then return t
the Auto-empty Station.
• If you move the Water Station after marking its position, remember to update its
position via the app.
O After marking the Water Station position, control your robot vi
our app or pressthe (Q)
button on the robot to start. Your robot
will start cleaning from the Auto-empty Station.
Starting Your Robot
O Pressthe@) button on your robot, and your robot will plan
the cleaning route dynamically based on the scanned map.
O Before mopping, your robot will go to the Water Station
(marked) to add clean water first, then return to the task starting
point to start.
O
Note:
For first-time use, your robot will
automatically work on the Vacuum
mode.
10
To Next Page
Loading...