3
Introduction
Please read this manual, it contains important safety information and guidelines on
how to get the most out of your Swytch Kit. The full and most up-to-date instruction
manual can be found online and should be consulted for any changes:
swytchbike.com/manual/go
Safety Warnings
To ensure a safe and trouble-free experience when using your Swytch Conversion
Kit please follow the guidelines below:
Kit intended use
The Swytch Kit is designed for roads and well-made paths. It’s not intended for
drops of more than 10cm, stunts, cross-country riding, or extreme sports. Misuse
may lead to the failure of some components and void your warranty. If your Power
Pack receives a significant impact, you should not continue to ride the kit, without
checking the safety with a Swytch representative. The product must be used in
compliance with your local laws and legislation.
Charger warnings
The Power Pack is safe for home use, but the charger and battery will gradually and
naturally heat up when it’s plugged in. Do not use a previous generation of charger
to charge your GO Powerpack, doing so will void your warranty. Avoid leaving your
Power Pack on charge for longer than necessary as this can lead to reduced
battery life. Provide adequate ventilation during charging.
Note: upgrade kits will not be provided with a plug, plugs can be recycled from
previous generation kits and used with a new charger block.
Power Pack warnings
Charge your Power Pack as soon as you receive your kit. Only use the Swytch
charger provided to charge your Power Pack. Charge your Power Pack every 90
days whilst in storage. Read the instruction manual thoroughly to reduce the risk
of injury or damage. This Power Pack must not be exposed to temperatures below
-10°C or above 40°C. The battery contains dangerous substances so do not
disassemble, pierce or soak in water.
Always turn off the main power button when not in use or in storage; otherwise, it
will slowly drain your battery. Always mount the powerpack using 3 velcro straps.
Use the buckle on each strap to tightly secure the Power Pack.
Always check after mounting that your Power Pack position does not affect the
brake function of your bike. If your strap starts to fray or break, then get in touch
with our team for a warranty replacement.
To Next Page
Loading...
