Need help?Do you have a question about the Swytch Universal eBike Conversion Kit and is the answer not in the manual?
Charge the Power Pack fully until the charger light turns green before first use or fitting.
Avoid leaving the Power Pack on charge for longer than necessary to prevent reduced battery life.
Ensure the Power Pack clicks into place on the handlebar mount for correct operation.
Ensure all nuts, screws, and bolts are tight before riding and check wheel spokes every 100km.
Install the motor wheel on the left of the bike, adjust brakes, and tighten wheel nuts.
Mount the sensor close to the magnets on the left of the bike, smooth side facing the sensor.
Tilt the mount 45° upwards when fitting the strap for tension when horizontal.
Firmly press connectors together and secure cables to the bike frame.
Instructions for removing the old wheel, fitting the motor wheel, and installing the disc brake.
Guide to installing the universal pedal sensor based on gap and pedal arm shape.
Steps for fitting the Easy Fit Regular or Thin Magnet Disk to the crank axle.
Instructions for fitting the Universal Magnet Disk using cable ties to the pedal arm.
Steps to correctly align the pedal sensor with the magnet disk for proper detection.
Instructions for fitting the handlebar mount, including spacers and the anti-twist strap.
Guidance on fitting the torque washer for Brompton bikes, including cable routing and mudguard placement.
Steps for installing the Brompton-specific pedal sensor, including identifying pedal types.
Correct mounting locations and angles for the Brompton pedal sensor.
Instructions for replacing the standard peg with the extended peg for Brompton bikes.
How to attach the adapter to the Brompton front carrier mount for power pack mounting.
Advice on brake pad clearance, cable routing for folding, and final checks.
Instructions for fitting brake sensors to control motor cutoff when brakes are applied.
How to attach hydraulic brake sensors to the brake lever for motor control.
Steps for installing the universal torque arm to secure the motor wheel.
Instructions for fitting the Torque Narrow component on the right-hand side of the bicycle.
Guide to fitting the twist throttle to the handlebars and adjusting hand grips.
Guide to fitting the thumb throttle to the handlebars and adjusting hand grips.
How to attach and detach the Power Pack from the handlebar mount, including tips for difficult removal.
Steps to turn on the battery and charge the Power Pack using the charge port.
How to access and adjust settings like wheel size, top speed, power limit, and PAS direction.
Common error codes displayed by the system and their corresponding solutions.
Solutions for a motor wheel that is not spinning freely, checking brakes and fork clearance.
Advice on fitting the pedal sensor magnet when there is limited space, suggesting alternative mounting.
Troubleshooting intermittent pedal assist power by checking the PAS magnet disk and sensor alignment.
Solutions for when the handlebar mount moves up during Power Pack removal, checking screws and spacers.
How to fix a sagging or loose handlebar mount by adjusting the twist strap and tilt angle.
Tips to make removing the Power Pack easier, suggesting wiggling and rocking motions.
A step-by-step guide to diagnose and fix common operational issues with the kit.
Further troubleshooting for motor starting/stopping issues during pedal assist, focusing on connections and sensors.
General| Brand | Swytch |
|---|---|
| Model | Universal eBike Conversion Kit |
| Category | Bicycle Accessories |
| Language | English |
To Next Page
