24 25
5.2.3 Pedal Sensor Alignment
Attach Pedal Sensor to bike
- Remove the pedal sensor adhesive cover.
- Attach the pedal sensor to the frame of the bike
close to the magnet disk.
Line up sensor to magnet arc
- Make sure that the centre of the sensor is aligned
to the magnets.
- Point the sensor away in a straight line from the
centre of the disk.
- As the magnet disk spins the magnets need to pass
close to the sensor for it to detect your pedalling.
Check correct installation
- The photo below shows a correctly fitted pedal sensor.
Adjust the pedal sensor to minimise the gap between the
sensor and the magnet. Tighten the screw to prevent it from
moving.
Cable tie in place
- Once fitted correctly, use the cable ties provided to secure
the pedal sensor to the frame. Route the wire along the
down-tube of the bike up to the handlebars, using the cable
ties to secure to the frame.
Make sure magnet
disc passes close
to sensor
1
2
3
4
To Next Page
Loading...
