Commissioning your SXT scooter
31
8. Insert the seat post into the receptacle on the rear end of the plate. Insert the saddle clamp onto the upper end, push the
telescopic post in the correct position and close the clamp. (see picture 7)
9. Attach the saddle to the adjustable seat post and tighten the saddle screws with the supplied tool. (see picture 8)
10. Mount the headlight (only for EEC models) (see picture 9 + 10)
11. Install the license plate bracket (only for EEC models) (see picture 11)
12. Mount the mirrors to the intended position on the handlebar with a rotating thread. (only for EEC models)
13. Make sure all screws on the scooter are tight.
14. Fully charge your SXT scooter.
Please scan the QR code to get to the building up video.
To Next Page
Loading...
