7. FAQs
46
The brake intensity is more less, what can I do?
Brake pads wear off during use. All disc brakes always have an inner and outer brake pad. The inner (towards the wheel) is al-
ways fixed, while the outer one can move back and forth. After a certain time, the inner lining must therefore be readjusted and
easily adjusted to the brake disc back to ensure a uniform & safe braking. For this purpose, adjust the large adjusting screw on
the inner side of the brake caliper accordingly.
My lithium battery can not be charged even though the charger is correctly connected to the side charging socket
For safety reasons, the lithium batteries in this model can only be charged directly at the connection cable on the battery itself.
The side charging socket on the vehicle frame does not work in conjunction with our lithium batteries.
My lead battery can not be charged even though the charger is correctly connected to the side charging socket
Charging only works if the fuse is correctly inserted in the fuse holder on the wiring of the battery.
Another reason may be an incorrect and / or interrupted wiring between the individual battery cells.
The typical statement: my scooter „does nothing“
As a rule, the mistake here is that somewhere a plug is loose or it fails on a loose contact.
Something small, which prevents the scooter from flowing electricity in all important parts. For example, it may also be due to a
missing flat fuse / non-activated main fuse.
The scooter is activated, ie front light is on, the LEDs are also lit but the engine is not rotating: 1. The kickstand
must be folded up for the throttle to work. 2. Check the connections on the control unit here.
Disconnect and reconnect individually. Also check the wiring of the throttle - this is the cable, which from the throttle grip
come follow and check.
My scooter can be switched on, but can not be turned off when the throttle is pressed
The side stand must be folded up so that the scooter can start. It may happen that the mechanism on the side stand does not
work. This must then be replaced so that the scooter works again.
To Next Page
Loading...
