79Installing UNIX agents
Installing an agent in silent mode
■ On the computer on which the agent will be installed, create a directory and
then copy the file agent-cert.ssl into the directory using FTP in binary mode
or some other protocol.
The directory path name cannot contain spaces.
To install an agent in verbose mode
1 Open a Terminal window and become superuser.
2 Insert the installation CD and if necessary, mount the volume.
3 Type and run the following command:
cd /mnt/cdrom
4 Type and run one of the following commands:
5 Please indicate whether you agree to the license agreement.
6 Follow the prompts until the installation completes.
7 On Solaris or Linux, restart the computer if prevention was enabled.
Installing an agent in silent mode
You can use the silent installation for UNIX installations.
Note: The required options for silent installation are -silent, -server, and -cert.
Sun Solaris 8.0/9.0 ./agent-solaris-sparc.bin
Sun Solaris 10 SPARC ./agent-solaris10-sparc.bin
Sun Solaris 10 x86 ./agent-solaris10-x86.bin
Red Hat Enterprise Linux ES 3.0 ./agent-linux-rhel3.bin
Red Hat Enterprise Linux ES 4.0 ./agent-linux-rhel4.bin
SUSE Enterprise Linux 8 ./agent-linux-sles8.bin
SUSE Enterprise Linux 9 ./agent-linux-sles9.bin
HP-UX on PA-RISC ./agent-hpux-hppa.bin
HP-UX on Itanium 2 ./agent-hpux-ia64.bin
AIX ./agent-aix.bin
Tru64 UNIX ./agent-tru64.bin
To Next Page
Loading...