Table 6-3
Recovery point options
DescriptionOptions
Type a name for your backup.
Note: This option does not appear if you
create a recovery point using the Back Up
MyComputer feature in Symantec Recovery
Disk.
Name
Select one of the following compression
levels for the recovery point.:
■ None
■ Standard
■ Medium
■ High
See “Compression levels for drive-based
backups” on page 74.
The results can vary depending on the types
of files that are saved in the drive.
Compression
Select this option to automatically test
whether a recovery point or set of files is
valid or corrupt.
Verify recovery point after creation
Select this option to limit the number of
recovery point sets that can be saved for this
backup. You can limit the number of
recovery point sets to reduce the risk of
filling up the hard drive with recovery
points. Each new recovery point set replaces
the oldest set on your backup destination
drive.
This option only appears if you are creating
a recovery point set.
Note: This option does not appear if you
create a recovery point using the Back Up
MyComputer feature in Symantec Recovery
Disk.
Limit the number of recovery point sets
saved for this backup
65Backing up entire drives
Defining a drive-based backup
To Next Page
Loading...
