To Next PageTo Next Page
Need help?Do you have a question about the Symetrix SX202 and is the answer not in the manual?
Details the SX202's ultra low noise, low distortion mic preamps and their symmetrical slew rates.
Explains gain controls, clip LEDs, and the 15dB pad for signal level adjustment and overload indication.
Describes the polarity switch on Channel 1 for signal phase correction and cable issue troubleshooting.
Details the 48V phantom power supply for condenser microphones and its compatibility with various mic types.
Presents a schematic block diagram illustrating the signal flow and components of the SX202.
Details the rear panel connectors including power, line outputs, and microphone inputs with their specifications.
Explains the function of each front panel control and indicator, including Power, Polarity, Pad, Clip, Gain, and Phantom Power.
Provides instructions on obtaining a Return Authorization (RA) number before sending the unit for service.
Outlines the steps for in-warranty repairs, including packaging, documentation, and shipping procedures.
Explains the billing process for out-of-warranty repairs, including parts, labor, and freight charges.
Details the SX202's ultra low noise, low distortion mic preamps and their symmetrical slew rates.
Explains gain controls, clip LEDs, and the 15dB pad for signal level adjustment and overload indication.
Describes the polarity switch on Channel 1 for signal phase correction and cable issue troubleshooting.
Details the 48V phantom power supply for condenser microphones and its compatibility with various mic types.
Presents a schematic block diagram illustrating the signal flow and components of the SX202.
Details the rear panel connectors including power, line outputs, and microphone inputs with their specifications.
Explains the function of each front panel control and indicator, including Power, Polarity, Pad, Clip, Gain, and Phantom Power.
Provides instructions on obtaining a Return Authorization (RA) number before sending the unit for service.
Outlines the steps for in-warranty repairs, including packaging, documentation, and shipping procedures.
Explains the billing process for out-of-warranty repairs, including parts, labor, and freight charges.
General| Channels | 2 |
|---|---|
| Signal-to-Noise Ratio | > 100 dB |
| Gain Range | 26 dB |
| Damping Factor | > 200 |
| Frequency Response | 20 Hz to 20 kHz |
| Total Harmonic Distortion | <0.05% |
| Input Sensitivity | 1V |
| Dimensions | 19" |
| Input Impedance | 20 kOhms balanced, 10 kOhms unbalanced |
