Symmetricom TimeCreator 1000 Release Notice

Page 2 097-93100-02 Revision H – February 2010
 Support for multiple remote syslog servers (up to 8)
 Added SNMP query function for all current alarms and events
 Added SNMP query function for all past alarms and events
 Enhancement of the "set authentication tacacs+ address <IP-address>" command to support
configurable TACACS port
 Enhancement of the "set authentication radius address <IP-address>" command to support
configurable RADIUS port
 Enhancement of the "show inventory" command to display the IOC part number
 The "generate Message" cli command, which is used to test trap generation, has been
improved to generate one specific simulated trap
 Introducing 8 port DTI for low port entry level deployments
Modified CLI Commands
 set remote-syslog add ip
 set remote-syslog delete ip
 set remote-syslog delete all
 show snmp accessv3
 show snmp accessv2
 show snmp trap
 set snmp accessv2 {disable | enable}
 set snmp accessv2 rocommunity
 set snmp accessv2 rwcommunity
 set snmp accessv3 add v3user SecureLvl {noauth|auth|priv} AccessLvl {ro|rw}
 set snmp accessv3 delete v3user
 set snmp trap add destination[:<port #>] [trapuser]
 set snmp trap delete destination
Deleted CLI Commands
 clear log
 history
Resolved Issues
 24906: SSH does not work with RADIUS/TACACS+
 08951: Incorrect configuration of Port 12 can inadvertently cause a timing loop in Root Server
Recovery (RSR) mode. The problem was fixed by prohibiting creation of the timing loop.

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English