What to do if Symmetricom Server has loose or damaged connectors?
If you find loose connectors on your Symmetricom Server, tighten them. If a connector is damaged, replace the connector and/or cable at the first opportunity.
How to clean dirt from Symmetricom TimeCreator 1000?
To clean your Symmetricom Server, use a soft, dry cloth to wipe the exterior of the chassis.
General| Brand | Symmetricom |
|---|---|
| Model | TimeCreator 1000 |
| Category | Server |
| Language | English |
Explains the scope and content of the TimeCreator 1000 User's Guide.
Details the sections and appendixes included in the user guide.
Explains typographical and formatting conventions used throughout the document.
Defines the meaning of different informational icons and their importance.
Introduces the TimeCreator 1000 as a DOCSIS Timing Interface Server and its role in M-CMTS.
Describes the EIA-232 serial and Ethernet connections for system provisioning.
Details the different operational modes of the TimeCreator 1000, such as warm-up and holdover.
Explains how to monitor performance metrics like jitter, MTIE, and frame error rate.
Details the front and rear panel components, including IOC, IMC, and DTI interfaces.
Lists part numbers for various system configurations and components.
Specifies the tools and materials needed for installation and testing the TimeCreator 1000.
Covers initial considerations before installation, including site survey and environmental requirements.
Details the process for mounting the TimeCreator 1000 shelf into a rack.
Explains how to handle, install, and remove the device's plug-in modules.
Guides on connecting GPS, Ethernet, and serial ports for system communication.
Details the procedures for establishing proper grounding and electrical power connections.
Describes how the TimeCreator 1000 handles TOD sources and manages time synchronization.
Explains how to log in/out, manage users, save configurations, and determine status via CLI.
Details methods for connecting to the device via serial or Ethernet ports for management.
Covers adding, deleting, and managing user accounts and their access levels.
Explains how to enable or disable core services like EIA-232, Telnet, SSH, NTP, and SNMP.
Describes how to configure the TimeCreator 1000 as a root or subtending server using GPS, NTP, or RTC.
Guides on configuring GPS and DTI parameters, including priority levels.
Details how to set and clear alarm thresholds and manage alarm states.
Explains procedures for backing up and restoring system configurations.
Outlines periodic maintenance tasks to ensure optimal unit performance.
Covers reading LED conditions and procedures for removing and replacing the IOC module.
Explains how to read IMC LED conditions and procedures for replacing the IMC module.
Details the process for upgrading firmware on IMC and IOC modules using CLI commands.
Provides instructions for returning the unit for repair, including repacking and RMA procedures.
Lists system notification messages for alarms, their descriptions, and corrective actions.
Provides MIB var bindings for Symmetricom-specific SNMP traps.
Introduces the Command Line Interface and its general conventions and command structure.
Provides an alphabetical listing of all CLI commands with syntax, examples, and levels.
Displays a list of all standing (active) system alarms.
Used to backup, restore, or set configurations to factory defaults.
Displays GPS position, mode, satellite tracking status, and satellite vehicle information.
Displays IP configuration and status for Ethernet interfaces, including DHCP status.
Displays all assigned users and their access levels.
Displays the list of IP addresses currently on the system's whitelist.
Describes SNMPv2c and SNMPv3 support for network device management.
Explains NTP's role in synchronizing system clocks over a TCP/IP network.
Covers connecting the GPS antenna signal and installing the antenna itself.
Lists detailed mechanical, environmental, power, serial, LAN, input, and output signal specifications.
Details default settings for GPS, DTI port parameters, IMC, communication, and alarm configurations.
Provides a list of third-party software applications included with the TimeCreator 1000.
To Next Page
