232 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
Show NTP
This command displays the NTP configuration, including server addresses, polling
intervals, preferred server, and key information.
Command Syntax:
show ntp
Example:
tc1000>show mode
Response:
NTP Authentication: Disabled
NTP configuration:
Servers: (*: Prefer server)
127.127.45.0 minpoll 4 maxpoll 6
192.168.83.180
192.168.3.98 *
NTP Query:
remote refid st t when poll reach delay offset jitter
==============================================================================
SYMM_TE(0) .GPS. 0 l - 16 0 0.000 0.000 0.015
192.168.83.180 .STEP. 16 u - 1024 0 0.000 0.000 0.000
*192.168.3.98 192.168.10.44 2 u 845 1024 377 1.292 0.048 0.207
Level : User, Power-User and Admin