EasyManuals Logo

Symmetricom TimeCreator 1000 User Manual

Symmetricom TimeCreator 1000
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #187 background imageLoading...
Page #187 background image
097-93100-01 Revision C – February, 2010 TimeCreator 1000 Users Guide 187
Appendix B Command Descriptions and Communications Interface
CLI Commands
Show Authentication
Displays how the TimeCreator 1000 authenticates users. If applicable, it displays
the RADIUS server and key and TACACS+ server and key.
Command Syntax:
show authentication
Example:
To display the authentication status:
tc1000>show authentication
Response:
RADIUS Authentication - disable
RADIUS Server - None
RADIUS Key - None
TACACS+ Authentication - disable
TACACS+ Server - None
TACACS+ Key - None
Remarks: Authentication can be local, RADIUS, or TACACS+. Authentication can
also be disabled, but not local.
Related: None
Level : Power-User and Admin only
Set Authentication
Use this command to provision the authentication scheme, the RADIUS server IP
address and the authentication key(s) for server access, or the TACACS+ server IP
address and the authentication key(s) for server access. Only one RADIUS or
TACACS+ server is supported at any one time. Only one key is supported at any
one time. This command also allows the user the option to specify the server port in
addition to the server address.
Command Syntax:
To provision the state of RADIUS authentication:
set authentication radius {enable | disable}
To provision the state of TACACS+ authentication:

Table of Contents

Other manuals for Symmetricom TimeCreator 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeCreator 1000 and is the answer not in the manual?

Symmetricom TimeCreator 1000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeCreator 1000
CategoryServer
LanguageEnglish

Related product manuals