Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 211
Appendix B Command Descriptions and Communications Interface
CLI Commands
Show Interface
This command displays the port state (enabled or disabled) for the GPS, client, or
server ports. It also displays the reference priorities and the port number, type, test
mode, and state.
Command Syntax:
show interface
Example:
tc1000>show interface
Response:
Interface State
---------------------------------
|Port |State |
|----------|--------------------|
|GPS |disable |
|..........|....................|
|Port1 |enable |
|..........|....................|
|Port2 |enable |
|..........|....................|
|Port3 |enable |
|..........|....................|
|Port4 |enable |
|..........|....................|
|Port5 |enable |
|..........|....................|
|Port6 |enable |
|..........|....................|
|Port7 |disable |
|..........|....................|
|Port8 |disable |
|..........|....................|
|Port9 |disable |
|..........|....................|
|Port10 |disable |
|..........|....................|
|PortA/11 |enable |
|..........|....................|
|PortB/12 |enable |
---------------------------------
Note: With the 8-port IOC module option, only DTI Ports 1 through 6
are active, in addition to Port A/11 and Port B/12.

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English