Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 85
Chapter 5 Provisioning
Setting the System Date, Time and Time Offset
Example
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
set ip-mode eth0 mode static and press Enter.
3. Type
set ip eth0 addr 192.168.0.10 and press Enter.
4. Type
set ip eth0 mask 24 and press Enter.
5. Type
set ip eth0 gateway 192.168.0.1 and press Enter.
6. Type
set ip-state eth0 restart and press Enter.
DHCP Mode
You can either enable or disable DHCP mode on the MGMT port or NTP port. Use
the following procedure to configure the TimeCreator 1000 to enable DHCP on the
MGMT port.
Example
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
set ip-mode eth0 mode dhcp and press Enter.
3. Type
set ip-state eth0 restart and press Enter.
Setting the System Date, Time and Time Offset
The TimeCreator 1000 Time of Day can be set either by an external source, or
manually with the Set Clock command. You can set the time and date only in the
user tod-source mode. The local time offset only affects the time associated with the
logs. Use the following procedure to manually set the system date, time, and time
offset:
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
set tod-source user and press Enter.
3. Type
set clock date <date value> time <time value> and press Enter.
Enter the date value in format yyyy-mm-dd.

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English