102 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Chapter 5 Provisioning
Provisioning Root Server Recovery Mode
how long re-alignment will take, in minutes (displays total time required, but does
not count down remaining time for re-alignment)
Example:
Root recovery status in the root server can be retrieved by using the following
query:
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
show root-recovery status and press Enter.
Enabling Rapid Recovery Mode
If the user decides that a shorter recovery is necessary, enter the following
command at the root server:
Set root-recovery rapidrecovery {port #|all} {enable | disable}
The Rapid Recovery mode can shorten the duration of the recovery process by at
least a factor of 10, depending on the phase error of the subtending server as a
result of the outage duration.
Example:
Rapid recovery mode can be enabled for all ports of the root server by using the
following commands:
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
show root-recovery status and press Enter to verify the status of the
root server recovery process and expected time for re-alignment.
3. Type
set root-recovery rapidrecovery all enable and press Enter.
Aborting Root Server Recovery
Use the command “set root-recovery autorecoverymode abort ” to abort the root
server recovery process.
Note: If a shorter recovery is necessary, enable rapid recovery
for all ports or for each individual port