EasyManuals Logo

Symmetricom TimeCreator 1000 User Manual

Symmetricom TimeCreator 1000
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #193 background imageLoading...
Page #193 background image
097-93100-01 Revision C – February, 2010 TimeCreator 1000 Users Guide 193
Appendix B Command Descriptions and Communications Interface
CLI Commands
Show Clock
This command displays the system’s date, time, leap seconds, and local time offset.
Command Syntax:
show clock
Example:
tc1000>show clock
Response:
Date - 2010-01-13
Time - 06:47:46
Local Time Offset - +00:00
IMC Uptime - 9:43
Leap Seconds - 14
Remarks: If the Show Clock command and the Show DTI-Clock command
time/date values are different and the unit is not in warm-up, then a "jam-sync" is
probably required (see Sync TOD-Source command).
Related:
show DTI-clock, set clock
Level : User, Power-User and Admin
Set Clock
Use this command to provision the IMC’s user-assigned date, time, leap seconds,
and local time offset.
Command Syntax:
To set the date and time for the IMC clock-
set clock date <yyyy-mm-dd> time <hh:mm:ss>
To set the local time offset for the IMC clock -
set clock offset <value>
To set the leapseconds value for the IMC clock -
set clock leapseconds <value>
Example 1:
To set the IMC clock to a date of 2010-02-12 and time of 11:23:44 -

Table of Contents

Other manuals for Symmetricom TimeCreator 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeCreator 1000 and is the answer not in the manual?

Symmetricom TimeCreator 1000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeCreator 1000
CategoryServer
LanguageEnglish

Related product manuals