194 TimeCreator 1000 User’s Guide 097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
tc1000>set clock date 2010-02-12 time 11:23:44
Example 2:
To set the local time offset to -8:00 for the IMC clock -
set clock offset -8:00
Example 3:
To set the leapseconds to 12 for the IMC clock -
set clock leapseconds 12
Remarks: The date and time can only be set in the user tod-source mode. The leap
seconds value can only be set in the user and NTP tod-source modes. The leap
seconds value is the accumulated number of seconds between GPS and UTC time.
The local time offset only affects the time associated with the logs.
Table B-2 provides a list of supported time zone offsets:
Restrictions: The Date format is yyyy-mm-dd.
The Time format is hh:mm:ss.
The Local Time Offset is hh:mm
Related:
show clock, show dti-clock
Level : Power-User and Admin only
.
Note: If the offset is changed, then the unit saves the configuration
and restarts.
Table B-2. Time Zone Offsets
Supported Time Zone Offsets
-12:00 -11:00 -10:00 -9:00 -8:00 -7:00 -6:00 -5:00 -4:00 -3:30
-3:00 -2:00 -1:00 +0:00 +1:00 +2:00 +3:00 +4:00 +4:30 +5:00
+5:30 +6:00 +6:30 +7:00 +8:00 +9:00 +9:30 +10:00 +11:00 +12:00
To Next Page
Loading...
Need help?
General
