Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 109
Chapter 5 Provisioning
Routine Operation Commands
 Summary for the GPS Input
 Number of standing system alarms
 Currently selected TOD Source
 System date and time
 Uptime for the IMC
 Clock operating mode for the IOC
 Assigned asset tag
To display the system status, enter the following:
Type
show status and press Enter.
Routine Operation Commands
This section describes the commands you use to perform the following routine
operations with the TimeCreator 1000:
 Displaying alarms
 Displaying events
 Restarting the server IMC card
Displaying Alarms
The Show Log Alarm command displays some of the local alarms in the alarm log in
chronological order (first in - first out). This command also allows the user to display
a specified number of alarms from the beginning or end of the log file.
Example
Type
show log alarm and press Enter.
Displaying Events
The Show Log Event command displays some of the local events in the event log in
chronological order (first in - first out). The event log contains the 1000 most recent
alarmed and non-alarmed events. This command also allows the user to display a
specified number of alarms from the beginning or end of the log file.
Example
Type
show log event and press Enter.

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English