EasyManuals Logo

Symmetricom TimeCreator 1000 User Manual

Symmetricom TimeCreator 1000
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
097-93100-01 Revision C – February, 2010 TimeCreator 1000 Users Guide 67
Chapter 4 General Guidelines for using the Symmetricom TimeCreator 1000
CLI commands
Show status (general status of unit)
Show gps (GPS information)
Show inventory
See Backing up Provisioning Data, on page 110 for additional details.
Enabling Outputs
Enter the following command to set the interface state.
Example for port 5:
Set interface state port 5 enable
Setting The Output To Test Mode
Enter the following command to set the interface test mode.
Example for port 9:
Set interface test-mode port 9 enable
Configuring For Default Mode (Real Time Clock)
Enter the following commands to set the TOD source to RTC”
Set tod-source rtc
Sync tod-source now
Configuring For User Mode
Enter the following command to set the clock in user mode:
Set tod-source user
Example to set the clock in user mode:
Set clock date 2006-05-20 time 10:23:00
Sync tod-source now
Configuring For GPS Mode
Enter the following commands to the TOD source to GPS:

Table of Contents

Other manuals for Symmetricom TimeCreator 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeCreator 1000 and is the answer not in the manual?

Symmetricom TimeCreator 1000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeCreator 1000
CategoryServer
LanguageEnglish

Related product manuals