Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 77
Chapter 5 Provisioning
Managing the User Access List
Changing a User’s Password and Access Level
Use the following procedure to change the password and access level.
1. Login at the Admin level (see Login, on page 74).
2. Type
show user and press Enter to view the current list of users.
3. Type
set user password <user> and press Enter. The system prompts you
for a password.
4. Type the user’s password and press Enter. The system responds with the
confirm password prompt.
5. Type the user’s password again and press Enter.
6. Type set user modify <user> access-level <access-level>and press Enter.
(The access level is 1, 2, or 3, where 3 is admin level.)
Note:
User passwords can consist of alphanumeric characters, “~”, “*”,
“(“,“)”, “!”, “?”, “-”, “_”, and “.” with a minimum of 8 characters and a
maximum of 32 characters.
Usernames can consist of numbers, upper and lower case letters,
dash "-", and underscore "_", with a maximum of 20 characters.
Usernames cannot use a leading dash “-” or underscore "_" as the
first character. Usernames cannot use any of the following
characters:
/ ( ) | \ ; : “ ‘ , < >
Passwords must contain at least one number or special character.
For a description of user access levels, see Managing the User
Access List, on page 74.

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English