EasyManuals Logo

Symmetricom TimeCreator 1000 User Manual

Symmetricom TimeCreator 1000
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #253 background imageLoading...
Page #253 background image
097-93100-01 Revision C – February, 2010 TimeCreator 1000 Users Guide 253
Appendix B Command Descriptions and Communications Interface
CLI Commands
Host: 192.168.3.45
SNMPv3 trap user: v3user1
Host: 192.168.3.44
SNMPv3 trap user: v2user2
Example 3:
>show snmp accessv2
Response 3:
SNMPv2 is enabled
SNMPv2 read only community: public
SNMPv2 read write community: private
Related: set snmp
Level: User, Power-User and Admin
Set SNMP
Use this command to provision the SNMPv3 user assignments, trap destination
assignments, SNMPv2 state, and v2 community assignments.
In order to use SNMP traps, the user must specifiy the IP address of the destination
for the trap message. Up to 5 destinations can be specified. In order to send
notifications, you must enter at least one trap destination IP address.
SNMPv3 users can provisioned as one of three security levels: Private, Author, and
Non Author. SNMPv3 users can be provisioned as one of two access levels:
read-only and read-write.
The following figure shows the hierarchy for the
set snmp command:
Note: Response to this command refers to a “trap sink” or “host”,
which is equivalent to trap destination.

Table of Contents

Other manuals for Symmetricom TimeCreator 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeCreator 1000 and is the answer not in the manual?

Symmetricom TimeCreator 1000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeCreator 1000
CategoryServer
LanguageEnglish

Related product manuals