097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 233
Appendix B Command Descriptions and Communications Interface
CLI Commands
Set ntp-server
This command provisions which NTP servers to use, the minimum and maximum
poll intervals, if the server is preferred, and key ID. This information is used when
the TimeCreator 1000 is acting as an NTP client.
Command Syntax:
To add a new NTP server, its key ID, minimum and maximum poll intervals, and if
the server is preferred -
set ntp-server add <server ip-address> [key <keyid>] [min
<value>] [max <value>] [preferred {yes|no}]
To modify an existing NTP server, its key ID, minimum and maximum poll
intervals, and if the server is preferred -
set ntp-server modify <server ip-address> [key <keyid>] [min
<poll value>] [max <poll value>] [preferred {yes|no}]
To delete an NTP server -
set ntp-server del <server ip-address>
Example 1:
To add an NTP server with IP address 192.168.15.86, a key ID of 41267, a
minimum poll interval of 16 seconds (<poll value> = 4), a maximum poll value of 256
seconds (<poll value> = 8), that is preferred:
tc1000>set ntp-server add 192.168.15.86 key 41267 min 4 max
8 preferred yes
Example 2:
To modify the minimum and maximum poll intervals of the NTP server at IP address
192.168.15.86 to 32 seconds (<poll value
> = 5) and 512 seconds (<poll value> = 9),
respectively:
tc1000>set ntp-server modify 192.168.15.86 min 5 max 9
Example 3:
To delete the NTP server at IP address 192.168.15.86:
tc1000>set ntp-server del 192.168.15.86
To Next Page
Loading...
Need help?
General
