Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 221
Appendix B Command Descriptions and Communications Interface
CLI Commands
Show IP
This command displays the Host address, Mask, and Gateway IP settings for both
Ethernet interfaces. It also indicates if DHCP is enabled for the interface and if the
interface is disabled.
Command Syntax:
show ip {config | status}
Example 1:
To display the IP configuration -
tc1000>show ip config
Response 1:
eth0 config:
mode: dhcp
addr: 192.168.5.62
netmask: 255.255.255.0
broadcast: 192.168.5.255
gateway: 192.168.5.1
eth1 config:
mode: static
addr: 10.0.0.101
netmask: 255.255.255.0
broadcast: 10.0.0.255
Example 2:
To display the IP status -
tc1000>show ip status -
Response 2:
eth0: negotiated 100baseTx-FD flow-control, link ok
eth1: negotiated 100baseTx-FD flow-control, link ok
eth0 Link encap:Ethernet HWaddr 00:B0:AE:01:25:85
inet addr:192.168.5.62 Bcast:192.168.5.255
Mask:255.255.255.0
UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2238869 errors:0 dropped:0 overruns:0 frame:0
TX packets:4798 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:139427807 (132.9 Mb) TX bytes:452343 (441.7 Kb)
Interrupt:9 Base address:0xc000

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English