Symmetricom TimeCreator 1000 User Manual

097-93100-01 Revision C – February, 2010 TimeCreator 1000 User’s Guide 267
Appendix B Command Descriptions and Communications Interface
CLI Commands
Show Whitelist
This command displays the list of IP addresses on the whitelist.
Command Syntax:
show whitelist
Example:
tc1000>show whitelist
Related: set whitelist
Level : User, Power-User and Admin
Set Whitelist
Use this command to add or delete IP addresses to/from the whitelist. Once the first
IP address has been added to the whitelist, any future IP sessions will only be
accepted if they originate from IP addresses from the whitelist. In the default
condition, all IP addresses are allowed access.
Command Syntax:
 Use this command to add an IP address to the whitelist:
set whitelist add <ip address>
 Use this command to add an IP address and ip mask to the whitelist.
set whitelist add <ip address>/<ip mask>
 Use this command to delete an IP address from the whitelist.
set whitelist delete <ip address>
 Use this command to commit changes to the whitelist. The whitelist must be
committed before any changes to the whitelist will be implemented:
set whitelist commit
 Use this command to set the whitelist to default conditions, where all IP
addresses are allowed access:
set whitelist default
Example 1:
To add the IP address 192.168.5.10 to the whitelist:

Symmetricom TimeCreator 1000 Specifications

General

Brand	Symmetricom
Model	TimeCreator 1000
Category	Server
Language	English