Synca JP-3000 - Page 57

・When customizing the air pressure, press “Skip” to
skip the setting.
・Even if is not pressed, registration will start after
about 10 seconds.
・Do not turn off the power during registration, other-
wise the registration of customized information cannot
be completed.
・In order to maintain a state where massage can be
performed immediately, the back line information will
not be deleted. After user information reset, if you
cancel before the new setting of customized back line
overwrites the old information, the back line informa-
tion will keep the latest set values.
1. Press and turn on the power.
2. Select which one you want to be registered
from “A/B (①)”.
3. Press “Start (②)” and then start to customize
WKHVHWWLQJVLQWKHRUGHURIEDFNOLQHĺUHFOLQLQJĺ
air pressure.
4. After the registration of customized information is complete,
the screen will return to me
When using the User Customized Mode for the first time
②
①
1. Log in to A or B and press “Settings”.
After pressing reset user setting , the device will start customizing settings
LQRUGHURIEDFNOLQHĺUHFOLQLQJĺDLUSUHVVXUH
To reset the user information (re-register)
・After the registration of customized information is complete, the User Customized Mode can be
used for massage. Operations are the same as those in Guest Mode. (P20~54)
・For various customize methods, please confirm the chapters on “Back Line (P58~59)”, “Reclining
(P60) ” and “Air pressure (P61) ”.
・If the registration of customized back line is not complete, User Customized Mode cannot be used.
・When customizing air pressure, press “Skip” to skip the setting.
・Do not turn off the power during registration, otherwise the registration of customized information
cannot be completed.
57