Installation
Unpack the unit from its shipping carton. Your ATT 2000 shipping carton
must contain the following:
The ATT 2000 Unit
User Manual
Phone Line Cords
Wall Adaptor
Select a suitable location for the ATT 2000 to be placed - it may be wall
mounted or kept on the tabletop. The suitable location should have 1 or 2
analog phone extension sockets, a power socket close by and should be
easily accessible for any service or maintenance work.
If you plan to mount the unit on the wall please follow the wall mounting
instructions given below:
Use the paper template, provided with the unit, and secure two wood screws
(Size 5 or 6) into the wall where you want to mount the unit. The distance
between the center points of the mounting screws should be 3 inches. The
wall on which the unit is to be mounted should be strong enough to support
the weight of the unit. Also make sure that the screws are driven securely into
the wall. Then, hang the unit onto the screws.
Precautions:
Do not install this unit where it would be subjected to :
! Direct sunlight, moisture or rain
! Heat sources, Radiators, Air Ducts etc.
! Draft from an air conditioner
! Excessive dust or corrosive fumes
! Mechanical shock or vibration
Plug in the Adaptor into the power socket and switch on the power to the
unit. The power lamp on the unit flashes rapidly for about 2 seconds, remains
steady for a second and then continues to flash once a second, indicating
normal operation.
Insert the phone line cord in the phone socket on the unit and insert the
other end into the wall extension socket for both the ports. Sometimes, when
the power is first applied or when the phone cord is inserted, the Power lamp
may glow steadily for about 5 seconds before returning to the slow On-Off
flashing state. This is normal and need not cause any concern.
You are now ready to do a Functional Check of the unit.
6
Installation
To Next Page
Loading...