Do you have a question about the Synel 785 and is the answer not in the manual?
Resolution | 320x240 pixels |
---|---|
Card Reader | RFID (optional) |
Communication | USB |
Power Supply | 12V DC |
Operating Temperature | 0°C to 45°C |
Details physical dimensions, weight, memory, reader, display, programming, communication, power, and environment.
Outlines optional features like Ethernet, Wi-Fi, POE, Biometric Fingerprint Reader, and External Readers.
Describes the product's construction, materials, and keypad design for durability and water resistance.
Details the LCD display, navigation keys, function keys, numerical keypad, and alarm light on the terminal's front.
Lists and describes the external connection ports available on the bottom of the terminal.
Explains the internal hardware, focusing on back-up battery modules for clock and power failure operation.
Covers user memory capacity and the function of internal batteries for clock and power failure support.
Instructions for checking the TA-785 package contents and ensuring no shipping damage.
Guidelines for selecting an installation location, considering environmental factors and interference sources.
Factors to consider for terminal placement, including EMI sources and cable proximity to power lines.
Step-by-step instructions for securely mounting the terminal, including panel removal and screw usage.
Procedure for accessing the terminal's configuration program, known as Technician mode.
Discusses asynchronous communication mode and programmable baud rates for terminal communication.
Explains RS-485 connectivity for multiple terminals and extended cabling distances.
Details direct RS-232 connections for single terminals and cabling distance limitations.
Outlines connection options via Ethernet and Wi-Fi networks, including IP address configuration.
Configuration options for RS-232 connections, including baud rate, station ID, and network settings.
Configuration parameters for Ethernet communication, including IP address, gateway, subnet mask, and ports.
General configuration details for Wi-Fi network setup and connection parameters.
Covers SSID for network identification and various authentication methods like Open, WEP, and 802.1x.
Details configuration for WPA PSK, WPA 802.1x authorization, and LEAP security protocols.
Step-by-step procedure to reset the Wi-Fi card, including disconnecting power and battery.
Procedure to clear memory errors and return the terminal to the 'NO PROG' state.
Warning and steps for qualified personnel to reset the terminal's memory using jumpers.
Identifies jumper locations and procedures for performing a memory reset.
Step-by-step guide for installing an internal Ethernet card into the terminal.
Step-by-step guide for installing an internal Wi-Fi card into the terminal.
Procedure for installing a Power over Ethernet (POE) card, including safety precautions.
Step-by-step instructions for installing a finger reader module into the terminal.
Procedure for installing a proximity reader into the terminal unit.
Steps to enroll employees using fingerprint templates via supervisor mode.
Process for re-enrolling employee fingerprint templates, including deletion and new enrollment.
Instructions for removing employee fingerprint templates from the terminal.
Guidelines and techniques for correct finger positioning on the fingerprint sensor for accurate scanning.
Specific procedures and tips for using the fingerprint unit effectively.
Manual steps to add transaction data into the terminal.
Introduction to the diagnostics mode for testing terminal components.
Detailed guidelines for using diagnostics to test readers, relays, LEDs, sensors, and keypad.
Steps to configure the proximity reader to identify and read different badge types.
A list of error codes with corresponding error messages for troubleshooting.
Wiring diagrams for controlling bells and access systems using terminal relays.
Explanation of how the internal relay controls signal output for access or bell ringing.
Illustrates the RS-232 connection setup between a Host PC and the terminal.
Detailed pin configuration for the HOST RJ-45 connector (RS-232).
Detailed pin configuration for the NET RJ-45 connector (Ethernet).
Detailed pin configuration for the READER RJ-45 connector (Magnetic/Barcode).
Specific pin configuration for the Barcode Reader connection.