Syntron Material Handling PowerPulse 7200-006-A - User Manual

Syntron® PowerPulse
TM
(115V) AC Control
■■■■■■■■■■■■■■■■■■■■■ INSTALLATION ■ OPERATION ■ MAINTENANCE
Thank you for buying your equipment from SYNTRON. This manual will help you to understand
how your equipment operates and what is required to maintain peak performance. Please read
it thoroughly and keep it on file for reference.
Your satisfaction is important to us, so please direct any comments to our Marketing
Communications department.
Date Purchased: ______________________
Part No.: _____________________________
Serial No.: ____________________________
Factory Order No.: _____________________
INTRODUCTION
The PowerPulse WT 115V AC control regulates the vibration amplitude of feeders and vibrators through phase
control provided by a triac (TRC). The printed circuit board (PCB) includes an OFF-ON line switch, a terminal
block, and a triac for full-wave AC phase control. It also includes a potentiometer for controlling the voltage to
the equipment. An intermittent switch provides the OFF/ON switching capability typically required when the
PowerPulse control is used with a flow switch or a parts detector.
SAFETY INSTRUCTIONS
Product safety labels must remain highly visible on the equipment. Establish a
regular schedule to check visibility. If safety labels should require replacement,
contact SYNTRON Material Handling, for an additional supply free of charge.
WARNING: These instructions and safety precautions must be followed. There is
a hazard of electrical shock to the operator. NOTE: Local safety codes and
regulations must be considered when installing and/or operating this control.
© 2014 Syntron Material Handling, LLC. All rights reserved. SM0091 082214

Syntron Material Handling PowerPulse 7200-006-A Specifications

General

Brand	Syntron Material Handling
Model	PowerPulse 7200-006-A
Category	Control Unit
Language	English

Summary

Introduction to Syntron PowerPulse AC Control

Safety Instructions for Syntron PowerPulse AC Control

Installation of Syntron PowerPulse AC Control

Power Supply Connection and Location

Ensure power supply matches nameplate and install in a clean, dry, vibration-free location. Connect via safety disconnect switch.

Electrical Connections and Grounding

Follow wiring diagrams, use grounding bushings for nonmetallic enclosures, and verify proper grounding during installation.

Enclosure Integrity Maintenance

Maintain enclosure integrity and use lid gasket to preserve NEMA 4X rating.

Operation of Syntron PowerPulse AC Control

Operational Procedures and Controls

Keep control closed and secured. Turn potentiometer clockwise to increase vibration amplitude, counterclockwise to decrease.

Maintenance of Syntron PowerPulse AC Control

Maintenance Safety Precautions

Disconnect power supply at the safety switch before performing any maintenance.

Cleaning Procedures

Keep controller clean. Use dry compressed air for cleaning; avoid damp cloths or water.

Troubleshooting Common Issues

Wiring Diagram for Syntron PowerPulse AC Control

Parts List for Syntron PowerPulse 115 V AC Control