Master Language is English Hot Runner System Installation Guide SVC-17-0001_EN-Rev11
RESTRICTED: Property of Synventive. - 396 - All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use. © 2019 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Single Axis Valve Gate Nozzle 16SVH
7) Remove the isolation nut (1).
8) Lift the complete actuator housing (8) from the guide sleeve (9).
Doc007285.png
Doc007432.png
9) Screw the 2 hexagon socket screws
(18) out of the guide sleeve (9),
heater band and bridge (4).
10) Take off the guide sleeve (9) from the heater band (14).
Doc007343.png
To Next Page
Loading...