Master Language is English Hot Runner System Installation Guide SVC-17-0001_EN-Rev13
RESTRICTED: Property of Synventive. - 89 - All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use. © 2021 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Actuator HB Series
8.1.1.4 HB Series seal kits
The picture shows the housing complete from actuator HB401606-10 as example.
Doc008516.png
At service, the parts from the seal set should be replaced.
Seal kit
HB250806-11
HB250806-15
HB250807-11
HB250807-15
HB401606-10
HB401606-15
HB401606-17
HB401607-10
HB401607-15
HB401607-17
Item Description Qty Item Qty Item
1 Seal Kit 1 SKT2508 1 SKT4016
1.1 Piston Seal 1 2G0/25-19-2.9 1 K30-40-40-32-3.2
1.2 Guiding Element 1 15.2X12X1.6/1.6 1 FB2.3-1.5L70.5
1.3 O-Ring Seal 1 VIOR-21.95X1.78-FPM-
75-G
1 VIOR-35X2.28-FPM-80-G
1.4 Rod Seal 1 C1-1028-V3664 1 C1-2038-V3664
1.5 Retaining Ring 1 DIN472-27X1,2 1 DIN472-42X1,75
1.6 Restrictor 1 EIS-TM-04-010 1 EIS-TM-04-010
NOTICE
1) All components must be cleaned (and oil free) prior to beginning assembly process.
2) All Seals and O-rings must be lubricated prior to installation.
3) This procedure is intended for use together with HCO-HB####-##, HB######-## drawings.
To Next Page
Loading...