Synway SMG4002 - 3.10.3 Tel to IP CallerID Manipulation

Synway Information Engineering Co., Ltd
SMG Series Wireless Gateway User Manual (Version 3.0.0) Page 65
Authentication
Mode
Sets the way for SIP to make outgoing calls (TelIP) on the gateway.
Option
Description
Do Not Register
(default)
SIP initiates a call in a point-to-point mode.
Register Port Group
SIP initiates a call with the registered SIP account and
password of the port group.
Register Port
SIP initiates a call with the registered SIP account and
password of the port.
Register Status
Registration status of the port group. See Figure 3-36. When Register Port Group
is set to No, the value of this item is Unregistered; when Register Port Group is set
to Yes, the value of this item may be Failed or Registered.
Port Select Mode
When the port group receives a call, it will choose a port based on the select mode
set by this configuration item to ring or to connect. The optional values and their
corresponding meanings are described in the table below.
Option
Description
Increase (default)
Search for an idle port in the ascending order of the port
number, starting from the minimum. If no match is found,
search repeatedly until finding a port which is allowed to
enter the call waiting state.
Decrease
Search for an idle port in the descending order of the port
number, starting from the maximum. If no match is found,
search repeatedly until finding a port which is allowed to
enter the call waiting state.
Cyclic Increase
Provided Port N is the available port found last time.
Search for an idle port in the ascending order of the port
number, starting from Port N+1. If no match is found,
search repeatedly until finding a port which is allowed to
enter the call waiting state.
Cyclic Decrease
Provided Port N is the available port found last time.
Search for an idle port in the descending order of the port
number, starting from Port N-1. If no match is found,
search repeatedly until finding a port which is allowed to
enter the call waiting state.
Group Ringing
Ring all the idle wireless ports in this port group.
Color Ring
Sets whether to enable the color ring feature or not, with the default setting of being
disabled.
Note: Only when there are available color rings and the “Port Select Mode” is set to
Grouping Ringing will this item appear.
Color Ring Index
The index of the color ring which is quoted by the current wireless port.
Port
The ports in the port group. If the checkbox before a port is grey, it indicates that the
port is not available or has been occupied. All selected ports for a port group will be
displayed in the Ports column in Figure 3-36. Note: When a port group contains
multiple ports, the automatic call forward feature is invalid.