To Next PageTo Next PageWhy is Syqwest HydroBox Marine Equipment PC Software not receiving GPS information?
The PC Software might not be set up correctly, or there could be a connection issue between the PC and the GPS Receiver. To resolve this, first, correctly configure the PC Software in the “NMEA I/O” menu to the correct COM port and to a compatible NMEA string with your GPS Receiver. Second, check the connections between the PC and the GPS Receiver.
What to do if Syqwest HydroBox Marine Equipment Sensor State always shows Unknown?
If the Sensor State always shows Unknown, it indicates that the PC Software is not receiving communication from the Sensor. To fix this: 1) Check the connections between the PC and the Sensor. 2) Ensure the Sensor’s LED is blinking at 1 Hz, indicating it is ready for communication. 3) Verify that the software is set up to use the correct COM port for communicating with the Sensor.
What to do if Syqwest Marine Equipment PC Software is non-responsive or lagged?
If the PC Software is non-responsive or lagged, it might be because Thermal Printing is enabled but no TDU (Thermal Display Unit) is connected. Check the connection between the PC and the TDU, or disable Thermal Printing within the software.
How to fix Syqwest Marine Equipment Sensor State stuck in Power-up?
If the Sensor State is stuck in Power-up, it means the PC Software was executed after the Sensor had already been initialized. To resolve this, cycle the power to the HydroBox Sensor by removing and then reapplying power.
What to do if Green LED on Syqwest Marine Equipment Sensor blinks at 1 Hz but cannot establish communication with PC software?
If the Green LED on the Sensor blinks at 1 Hz but you can't establish communication with the PC software, it could be due to: 1) A connection problem between the PC and the Sensor. 2) The PC Software not being set up to use the correct COM port. To solve this: 1) Check the connections between the PC and the Sensor. 2) Select the correct COM port in the “Sonar Port” menu.
Why Green LED on Syqwest Marine Equipment Sensor does not turn on?
General| Brand | Syqwest |
|---|---|
| Model | HydroBox |
| Category | Marine Equipment |
| Language | English |
Lists the technical specifications for the HydroBox Sensor Unit.
Detailed technical specifications of the HydroBox Sensor unit.
Provides a general overview of physical and electrical setup for the HydroBox system.
Crucial notes on serial connections and converter compatibility for proper operation.
Details dimensions and mounting procedures for various HydroBox transducers.
Provides guidelines for locating and mounting the HydroBox Sensor Unit.
Outlines the steps and considerations for physically mounting the HydroBox Sensor Unit.
Details how to select a location and install the HydroBox transducer.
Details the electrical connections required for the HydroBox Sensor Unit.
Instructions for connecting the DC power supply to the HydroBox unit.
Explains how to connect the data interface cable for communication.
Describes the connection for the HydroBox transducer.
Step-by-step instructions for installing the HydroBox PC software.
Guides the user on operating the HydroBox Sensor via the PC Software.
Describes the layout and components of the main HydroBox PC software interface.
Details the self-tests performed by the HydroBox Sensor upon power-up.
Outlines the process for updating the HydroBox Sensor's firmware.
Details the procedure for updating firmware via the PC software.
Provides solutions for common hardware and software problems.
Troubleshooting steps for issues with the HydroBox Sensor.
Troubleshooting steps for issues with the PC software.
Comprehensive guide for updating both software and firmware.
