System Sensor MOD400R

To Next Page

Agency Listings

MOD400R

Field Sensitivity

Test Module

The MOD400R fulﬁlls the NFPA 72 requirement for

detector sensitivity testing.

Features

• Compatible with all System Sensor direct wire and plug-in smoke

detectors (100, 200, 300, 400, and 500 Series), or System Sensor

DH100, DH200, DH400, and DH500 Series duct smoke detectors,

ionization or photoelectronic

• Fulfills NFPA 72 requirement for field sensitivity testing

• Interfaces with standard DC voltmeter or multimeter

• Low battery diagnostic: when connected to a voltmeter, the

MOD400R monitors its own battery voltage

• Quickly tests sensitivity of detectors without putting system into

alarm

The MOD400R Field Sensitivity Test Module is designed to

check the sensitivity of System Sensor 100, 200, 300, 400, and 500

Series conventional detectors or System Sensor DH100, DH200,

DH400, and DH500 series duct smoke detectors. The test module can

be connected to any DC voltmeter (meter movement of 10K ohms/v

or greater) to obtain a reading which correlates to the detector’s

sensitivity range.

S2522 OX5A4.AY

Other manuals for System Sensor MOD400R

Need help?

Do you have a question about the System Sensor MOD400R and is the answer not in the manual?

General

Category	Test Equipment
Type	Test Module
Compatibility	System Sensor compatible devices
Operating Temperature	0 to 49 °C
Humidity Range	10% to 93% RH
Weight	0.5 lbs
Function	Monitors and tests 4-wire smoke detectors
Dimensions	4.5" x 4.5" x 1.5" (114mm x 114mm x 38mm)