SystemAir SAVE VTR 150/K User Manual (English)

Other manuals for SystemAir SAVE VTR 150/K

User Manual96 pages

Installation And Service52 pages

Installation Instructions18 pages

How-To8 pages

Questions and Answers:

T
tanya29Aug 17, 2025
How to troubleshoot SystemAir Air Handlers when the fans do not start?
- G
  Gregory AndrewsAug 17, 2025
  If the fans in your SystemAir Air Handlers aren't starting, begin by checking the HMI for any alarms. Next, verify that all fuses and fast couplings are properly connected, including the main power supply and the fast couplings for both supply and extract air fans. Also, ensure that the week schedule is turned ON and running in AUTO mode, as it might be in OFF mode with the airflow set to OFF.
D
David MunozAug 23, 2025
What to do if my SystemAir Air Handlers have low supply air temperature?
- J
  Jennifer LongAug 23, 2025
  If you're experiencing low supply air temperature with your SystemAir Air Handlers, check the display for any alarms. Also, verify if the Defrosting function is active in the HMI screen. Ensure the set supply air temperature in the HMI is correct and that ECO mode is not activated. Check if user modes like HOLIDAY, AWAY, or CROWDED are activated in the HMI or via a hardwired switch. Verify that the temperature sensors are functioning correctly by checking the analogue inputs in the service menu. If you have an electrical re-heater, check if the overheat protection thermostat is active and reset it if necessary. Also, check if the extract filter needs to be changed. If the unit has a re-heater battery connected, consider that very cold outdoor conditions might require it.
R
rhonda56Aug 30, 2025
How to reduce noise and vibrations in SystemAir Air Handlers?
- M
  masonjamesAug 30, 2025
  To address noise and vibrations in your SystemAir Air Handlers, start by cleaning the fan impellers. Ensure that all screws holding the fans are properly tightened. Check that the anti-vibration lists are correctly fitted to the mounting bracket and the back of the unit. If your unit has a rotating heat exchanger, verify that the rotor belt is not slipping.
A
Anthony MitchellSep 4, 2025
What to do if SystemAir Air Handlers unit cannot be controlled?
- S
  Steven StephensonSep 4, 2025
  If your SystemAir Air Handlers unit's control functions are stuck, try resetting them by unplugging the unit for 10 seconds. Additionally, check the modular contact connection between the HMI and the main printed circuit board.

SystemAir SAVE VTR 150/K Specifications

General

Model	SAVE VTR 150/K
Airflow	150 m³/h
Supply Voltage	230 V
Phase	1~
Frequency	50 Hz
Filter Class Supply Air	G4
Filter Class Extract Air	G4
Filter Class	G4
Heat Exchanger Type	Counterflow
Type	Heat Recovery Ventilation