Table of contents
1 Introduction .......................................................... 1
1.1 Product description ......................................1
1.2 Intended use ..............................................1
1.3 Product overview CB.................................... 1
1.4 Product overview RB.................................... 1
1.5 Product overview TG-KH/PT1000 ................... 2
2 Safety .................................................................2
2.1 Safety definitions......................................... 2
3 Installation............................................................2
3.1 To do before installation of the product ............. 2
3.2 To install the pre-heater ................................ 2
3.3 To use the manual overheat reset ...................3
4 Wiring diagram CU27 ............................................. 4
5 Wiring diagram CU283............................................ 5
6 For Topvex with Access control system from sw 4.
X....................................................................... 6
6.1 To set up the pre-heating function ................... 6
6.2 To activate the pre-heating function ................. 6
6.3 To configure the pre-heater............................ 6
6.4 To allocate the pre-heater.............................. 7
6.5 Operation settings ....................................... 7
6.6 To save commissioning settings...................... 8
7 For Topvex with control system sw 3.X ....................... 9
7.1 To set up pre-heating function ........................9
To Next Page
Loading...