_________________________________________________________________________________________________________________
Topvex TR 09, TR12 & TR15 Operation- and maintenance instructions
205000 Systemair AB
7
Table of contents - control unit manual
Actual/Setpoint (Temperature, Flow/Pressure) 8
Input/Output (Shows status and values) 9
Time Settings (Set Time and date)
(Set operating times, week and holidays) 9
Settings (Set Alarm limits e.g. temp. and deviation) 10
Manual/Auto (Set if the unit should run on manual on/off or auto) 10
Configuration
-Inputs/Outputs (Set and Show all In/Outputs) 11
-
Control function (Set control temperature mode) 12
-
Object Types (Set and activate Cooling function, 0..10VDC signal) 12
-
Pump control (Set control function for Heating/Cooling pump) 12
-
Free cooling (Activate function, make specific settings) 13
-
CO2/VOC Control (Activate function, make specific settings) 13
-
Fire Function (Set if unit should run or stop)
(Set the Fire alarm input to Normally closed/ open)
(Set if there are Fire dampers installed and when they
should be exercised) 13
- Humidity control (Activate functions and make specific settings) 13
-
Cooling recovery (Activate function, make specific settings) 13
-
External set point (Activate function, make specific settings) 14
-
Alarm configuration (Set alarm config. e.g. priority, stop the unit, -
temperature limits, pressure deviation etc.) 14
-Other parameters
Extended running (Set Extended running in minutes) 14
Outdoor temp for control-
mode change
(Set outdoor temperature for changing of control-
temperature mode) 14
Outd. temp for Blocking-
of 1/1-speed (Set the Outdoor temperature for blocking Normal-
and changing to Reduced fan speed.) 14
-
System
Choose Language
(Set menu Language) 15
Choose Start Screen (Choose between 5 different settings) 15
Automatic summer/winter-
time change over (Set if the internal clock should change automatic-
between summer and winter time) 15
Address: PLA ELA Only used when connected to Exo-network 15
Address for remote-
communication Set PLA:ELA addresses to external units 15
Communication code-
for modbus (Set if Modbus should be activated or not – 15
Access Rights
-Log on (Log on to any level by entering a 4-digit code) 16
-Log off (Log off from present level to the basic “no-log on” level) 16
-Change password (Change password for accessing different levels) 16
To Next Page
Loading...
