EasyManua.ls Logo

SystemAir villavent V20

SystemAir villavent V20
16 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
EXTRA INLET VALVE
TheprovidedinletvalvecanbeinstalleddirectlyinT-pieceon
pipesystemclosetothepowerunit.
Ifcyclonicseparationischosen,theinletvalvecanalternatively
bemounteddirectlyintothefreesuctionconnectoronthepower
unit.
NOTE! Ifyouchoosenottomountthisvalveonthepower
unit, the provided plug must be used to blind the free
suction connector.
Seepage2–g.9
SYSTEM TEST
After electrical connection, check the following:
• Thatdustcanister,lter,baglter(ifapplied)arecorrectly
installed.
• InsertthehoseintoallinletvalvesandcheckthatOFF/ON
(2 steps) functions are working.
• Checkpipesystemandinletvalvesforpossibleairleakage.
Seepage2-g.8
USE
Thecentralvacuumsystemiscontrolledfromaswitchonthe
hose/handle. Insert the hose into the inlet valve and turn the
switchtotheONposition,2steps(60%and100%capacity).
Turn the switch to OFF position to stop the unit. The unit should
be stopped beforeyouunplugthehosefromtheinletvalve.
Seepage2-g.8
LED INDICATORS
YourpowerunitisequippedwithamulticolorLED-panel.This
willprovideyouwithnecessaryinformationonyourpowerunit’s
performance, maintenance and diagnostics. Messages in the
LED-panelaredescribedbelow
ModelV20isonlyequippedwithOFF/ONLED-indicator.
ModelV30isequippedwithindicatorforOFF/ON,motorfault,
full dust canister and reset.
WhenthecentralvacuumunitisOFF,andinstandbymode,the
OFF/ON indicator will give a constant RED light. When the unit
is ON, and in use, this light will be GREEN.
ALARMS
V20
1. Motor fault: OFF/ON indicator gives a constant GREEN
light.
2. Shutdownduetoovervoltage:OFF/ONindicatorashing
RED,andGREENindicatorashesatahighspeed.
Automatic reset will occur after 15 sec. if switch on the
handle is in OFF position.
3. Ifovervoltageoccursrepeatedly,whiletheswitchonthe
handle is in ON position: OFF/ON indicator will give a
constantREDlightwhileGREENlampashesslowly.
4. Unevenvoltagesupply:Thecentralvacuumcleanerdoes
not start, OFF/ON indicator lights RED.
5. Voltage is to high: OFF/ON indicator alternate between
RED and GREEN light 3 times – short pause – alternate
betweenREDandGREEN3times-longpause.Thiswillbe
repeated until the voltage is back to normal.
V30
1. Motor fault: OFF/ON indicator gives a constant GREEN
light.
2. Shutdownduetoovervoltage:OFF/ONindicatorashing
RED,GREENindicatorashesatahighspeedand
indicatorformotorfaultashesatahighspeedwithayellow
light. Automatic reset will occur after 15 sec. if switch on the
handle is in OFF position.
3. Ifovervoltageoccursrepeatedly,whiletheswitchon
the handle is in ON position: OFF/ON indicator will give
aconstantREDlight,GREENlampashesslowlyand
indicatorformotorfaultwillashslowlyyellow.
4. Unevenvoltagesupply:Thecentralvacuumcleanerdoes
not start, OFF/ON indicator lights RED.
5. Voltage is to high: OFF/ON indicator alternate between
RED and GREEN light 3 times – short pause – alternate
betweenREDandGREEN3times-longpause.Thiswillbe
repeated until the voltage is back to normal.
6. Dust canister: The lamp for dust canister will light when it is
timetoemptythecanister/changethedustbag.Whenthis
hasbeendone,extinguishbypressingtheresetbuttonfor
10 sec.
MAINTENANCE
Reducedairoworsuctionindicatesmalfunction.Ifthebag
lter/dustcanisterisfull,orthelterisclogged,theairow/
suctionwillbereducedandthequalityofvacuumingless
efcient.Regularchangeofbaglter/emptyingofcanisteris
thereforeimportanttomaintainyourvacuumsystem’sfunction
andefciency.
Normallychangeofbaglter/emptyingofdustcanister2-3
timesayearshouldbesufcient.Releasethedustcanisterby
pressingthepush-buttonsonthecanistershandles,andthen:
• Releasethebaglterfromtheadapter.
• Placeandpressthenewbaglterontotheadapter.
• Remountthedustcanisterbypressingthepush-buttonsand
pullthecanisterontothexingbrackets..
Ifcyclonicseparationischosen(andnobaglterinstalled),
emptythedustcanisterbeforecleaningthelterandremounting
the canister.
Seepage2-g.11

Related product manuals