Need help?Do you have a question about the SystemAir VR 400 DCV and is the answer not in the manual?
Covers unit placement, access for maintenance, and wall considerations for noise.
Discusses air duct network, material recommendations, and system configuration for efficiency.
Explains how to connect the unit, cookerhood, and remote controls, including digital inputs.
Provides instructions for installing optional heating or cooling batteries.
Recommends separate rooms and considers maintenance access and noise insulation.
Advises on positioning fresh air intake (north/east) away from stale air sources.
Recommends galvanized steel ducts and flexible aluminum for connections, emphasizing low speed/pressure.
Details securing duct joints and installing sound attenuators to prevent noise transfer.
Explains that fine-tuning air volumes per room is done during commissioning based on ventilation design.
Describes the standard 1m cable and plug for 230V single-phase earthed connection.
Details connecting the cookerhood, including potential-free signal wiring and automatic fan speed increase.
Explains how to connect optional remote control panels (CD type) using 4-lead 12V cable.
Details installing a hot water battery, including valve motor signals, sensor replacement, and frost protection settings.
Explains installing a cooled water battery, its operation sequence, and configuration for cooling.
Covers setting up the hot water battery, including airflow and activation options.
To Next Page
General